![]() However the firmware keeps track of how much printing the printer does and flashes a message up long before the pads are literally full, though some printers can sense how full the pads get as the printer is used more and more. When it gets too full it can't hold any more ink and it would just effectively drip all over the innards of the printer and out the bottom. You can contact us through Live Chat or Ask a Question at the top of the page to find out if anything can be done for you under warranty.The ink absorber is basically a sponge that collects excess ink during normal printer operation. Use of some non-Brother inks is also a common cause of the problem since some non-Brother ink may clog the print head nozzles resulting in frequent cleaning cycles being needed to maintain print quality. These include frequently unplugging the machine or manually triggering cleaning cycles. There are however, several conditions that may cause the ink absorbers to fill faster than anticipated. If the machine is powered on, with no use for 45 days it will automatically clean the print head to help prevent ink from drying and clogging the ink nozzles. If an ink cartridge is replaced while the machine is unplugged it may automatically clean the print head when plugged back in. This is done to remove paper dust which can cause damage the print head. After a paper jam has been cleared the machine will automatically clean the print head prior to the next print job. When the machine is first set up it will perform an initial purge to fill the ink tubes during the initial installation of the ink cartridges. Over the normal expected life of the machine cleaning cycles will be performed automatically under the following conditions: For more information please contact our technical support through Live Chat or Ask a Question at the top of the page. In order to clear this message the ink absorbers inside the machine must be replaced. They can hold enough ink to last the normal expected life of the machine. These ink absorbers are used to hold ink after it has been purged from the print head during the print head cleaning cycles. ![]() The message Ink Absorber Full is an indication that the machines internal ink absorbers are almost full.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |